People call us because “there’s water under the AC,” “it smells damp,” or “the unit quit after it dripped.” Those are customer descriptions of a condensate drain problem. The drain line carries water away from the indoor coil, pan, and air handler.
Water can back up into the condensate pan when algae, dust, insulation fibers, or a broken fitting blocks that route. AC drain line cleaning should not wait, because a backup can trip the float switch, stop cooling, or overflow onto drywall, flooring, or a ceiling.
Water under the AC
We hear “the AC is leaking,” “there’s a puddle under the unit,” “it smells musty,” and “the system shut itself off.” Other calls involve a gurgle at the drain pipe, water dripping from a ceiling, or a wet spot near an attic air handler.
A clogged trap, cracked pan, stuck float switch, blocked PVC line, and frozen evaporator coil can create similar symptoms. We separate those faults during inspection because each one needs different labor, materials, and parts.
Condensate drain inspection
We inspect the condensate pan, PVC drain line, trap, drain termination, float switch, and air-handler cabinet. We check for standing water, loose joints, slime in the trap, and damage around the drain connection. We also trace the route and verify the pipe diameter; many residential systems use 3/4-inch PVC, but the existing fitting determines the replacement.
An accessible drain cleaning and flow test commonly takes 30 to 60 minutes. We usually clear accessible buildup, flush the line, and test water flow during the same visit. A separated line behind drywall, a damaged pan, or a condensate pump replacement may need a separate visit after we confirm the route and required part.
Float switches and PVC routes
Access to the air handler changes the work involved. A trap beside a closet unit is easier to reach than a drain line routed through an attic, wall, or ceiling cavity. The age and condition of PVC also matter, since brittle pipe can crack while an old blockage is being cleared.
A failed float switch, damaged trap, or worn condensate pump adds a part beyond line cleaning. A matching switch or pump may need to be ordered if the existing model is unusual. A drain reroute connected to plumbing may also require approval before that work begins.
Air-handler label and drain access
Before calling, find the model number on the air-handler data plate, usually behind the service panel or on the cabinet. Tell us which room has the puddle, ceiling stain, or musty vent. Let us know whether water is still running from the drain termination and whether the AC is operating or shutting off. Note whether the air handler sits in an attic, closet, garage, or ceiling cavity, and whether a ladder or hatch is needed. A photo of the pan, PVC trap, or float switch can show the access and fitting layout. Call (737) 239-8011; backed-up condensate can overflow the pan and damage drywall or a ceiling.
Looking for something else? Try furnace repair or the home page.