Skip to content
Cool Austin Air Conditioning

8701 Menchaca Rd & Davis Ln, Austin, TX 78748

Serving Austin · Rollingwood · West Lake Hills · Lost Creek

(737) 239-8011

Furnace Repair in Austin, TX

Furnace repair for no heat, ignition faults, blower problems, and burner concerns.

Call (737) 239-8011 Ask a question

A technician showing a tablet to a homeowner in a living room, the two of them talking

Older homes in Austin, Rollingwood, West Lake Hills, and Lost Creek often have furnaces with aging igniters, flame sensors, and blower motors. A unit can sit unused through much of the year, then show a fault on its first heating cycle.

We check gas furnaces and electric heating equipment at the cabinet, thermostat, return grille, and vent connection. Furnace trouble should not wait if there is a gas smell, burning odor, repeated shutdown, or no heat, because combustion and safety controls need testing before another cycle.

Furnace won't start, burning smell

A furnace that will not start may click, hum, or begin a blower cycle without producing warm air. A thermostat can call for heat while the igniter fails, the control board locks out, or a condensate switch remains open.

A burning smell, soot near the burner area, yellow flames, or a furnace that shuts off after a few minutes also needs a look. A loud rattle from the blower compartment can point to a loose wheel or motor issue.

Those signs can feel similar from a room, but an igniter, limit switch, gas valve, and blower assembly are different repairs with different parts and labor.

Ignition system inspection

At an ignition system inspection, we start at the thermostat call and confirm voltage at the control board. We inspect the filter, return airflow, door switch, wiring terminals, burner compartment, vent pipe, and flame sensor.

On gas equipment, we verify the ignition sequence, burner flame, and manifold pressure against the furnace rating plate. We test 24-volt safety circuits and 120-volt blower power.

An initial diagnostic check commonly takes 30 to 60 minutes. A dirty flame sensor, blown fuse, worn igniter, or loose terminal can often be handled during the visit; a failed control board, inducer motor, or nonstock gas valve may need a return visit after parts arrive.

Control boards, access, ordered parts

The furnace age matters because an older model may use an obsolete control board, inducer assembly, or gas valve. The serial and model plate tells us whether an original part is still available or an approved replacement is needed.

Access changes labor. An attic furnace, tight closet, rusted service panel, or seized gas shutoff can add disassembly and safe isolation before the failed part is reached.

Parts ordering also affects scope, especially for a matched control board or blower motor. Work involving altered venting or gas piping may need a required sign-off, which adds steps beyond a straightforward component replacement.

Rating plate and furnace access

Find the model and serial number on the rating plate, usually inside the furnace cabinet or behind the lower access panel.

Tell us which room has the thermostat and whether the blower runs, clicks, or remains silent after a heat call.

If you can see the furnace safely, note whether it is in an attic, closet, garage, or utility room and whether the access panel is clear.

Let us know if a filter was recently changed or if the display shows a code.

Do not remove burner covers or reset a tripped safety switch repeatedly.

Call (737) 239-8011; repeated failed ignition can leave the furnace locked out and the house without heat.

Looking for something else? Try get in touch or the home page.