Skip to content
Cool Austin Air Conditioning

8701 Menchaca Rd & Davis Ln, Austin, TX 78748

Serving Austin · Rollingwood · West Lake Hills · Lost Creek

(737) 239-8011

AC Replacement in Austin, TX

AC replacement planning and installation for aging systems in Austin.

Call (737) 239-8011 Ask a question

A technician crouching at an outdoor condenser unit beside a house, his open tool bag on the grass next to him

A system that runs all afternoon but leaves the living room warm can become a larger problem over a season. Long cooling cycles add wear to the compressor, blower motor, capacitor, and electrical connections. Water around the indoor unit can also damage the drain pan, ceiling, or nearby flooring if it continues.

An aging air conditioner does not always need immediate replacement. Replacement should not wait through another cooling season if the compressor has failed, the coil is leaking, or the unit cannot hold a safe indoor temperature, because those faults can leave the house without cooling and limit repair options.

Warm air and loud buzzing

Customers often call because the vents blow warm air, the outdoor unit makes a loud buzz, or the thermostat is set low but the house stays hot. Another common complaint is an AC that starts, clicks, and shuts off without finishing a cooling cycle.

Ice on the copper refrigerant line, water beneath the air handler, and a burning electrical smell are different symptoms. A dirty filter can restrict airflow, while a failed capacitor, refrigerant leak, damaged coil, or compressor fault needs a different repair or replacement decision. The symptoms can sound alike from inside the house, but the equipment fault and the replacement scope are not the same.

Equipment replacement inspection

We inspect the outdoor condenser, indoor coil, air handler, thermostat, disconnect box, drain line, pad, and refrigerant line set. We check the model plate, electrical supply, airflow path, filter size, duct connections, and the space around the equipment. A replacement inspection commonly takes 30 to 60 minutes, depending on attic access and the location of the indoor unit.

We use the existing system's capacity, duct layout, and room conditions to plan the replacement equipment. A matched system may include the condenser and evaporator coil, with electrical or line-set work if the existing parts are unsuitable. Equipment selection and installation are usually scheduled after the inspection; smaller items such as a filter or thermostat setting may be addressed during the visit.

Equipment access and line set

The equipment itself, attic or closet access, and the condition of the refrigerant line set all affect the replacement scope. A unit on a clear ground pad is different from a condenser behind a gate, on a roof, or beside dense landscaping. An air handler reached through a narrow attic opening can require more setup than one in a utility closet.

Older equipment can also affect the job because newer matched systems may need changes to the coil, drain connection, electrical disconnect, or line set. A damaged or undersized copper line may need replacement rather than reuse. Permit requirements, electrical corrections, and equipment that must be ordered can add steps before installation.

Model plate and attic access

Before calling, find the model and serial numbers on the outdoor condenser's data plate. The plate is usually mounted on the cabinet side near the electrical panel or refrigerant connections.

Note which rooms stay warm and whether the system is running now. Tell us whether the indoor unit is in an attic, closet, garage, or crawlspace, and whether a ladder or gate is needed to reach it.

A photo of the condenser, air handler, filter slot, and attic opening can help us plan the right equipment and access. Call Cool Austin Air Conditioning at (737) 239-8011 before a failing compressor turns intermittent cooling into no cooling at all.

Looking for something else? Try air duct cleaning or the home page.